That "let the FOD fall where it may" habit bit me on a 737 nose gear door
I used to roll my eyes at the old guys who spent ten minutes sweeping the hangar floor under an open panel before button up. Last Tuesday at our hangar in Fresno, a socket I dropped changing a nose gear door strut seal vanished, and I found it wedged in the actuator linkage two hours later, after the gear swing flagged a binding feel. I've done that job plenty of times without the sweep, so I figured it was overkill, but a $31 socket almost turned into a gear door that wouldn't latch. Now I do a walkaround of the deck before I close anything, even if it costs me three minutes. What's the weirdest spot you've found a dropped tool hiding in after you thought you were done?