Loading…
19
Pro tip: I stopped cutting drawer runners on the table saw and switched to the router table last month
Honestly I fought that change for 3 months because setup felt slower, but after doing 14 drawers for a kitchen in Salem the fit was dead on every time and I only scrapped one board instead of my usual five, so what setup trick do you guys use to keep the fence square when you're doing a run of them?
1 comments
Log in to join the discussion
Log In1 Comment
phoenix_grant7d ago
Wait, router table doesn't automatically fix your square problem, the fence on that thing can drift just as easy as a table saw fence if you don't lock it down. The real win you got was probably the bearing-guided bit cutting a cleaner edge, not the router itself. I still check my fence with a dial indicator every 10 drawers or so, takes two seconds and saves the whole run.
4