Warning: a single bent pin on a 38999 can pass a continuity check and still cost you a day
I found out from an old mil-spec connector guide that a pin can push back and still read good on a cheap meter, so now I wiggle-test every contact by hand before I button up a rack and I'm curious if anyone here uses a real pin retention gauge or just eyeballs it.
Watched a buddy chase this exact ghost for two days on a jet test stand. His meter said every pin was solid, so he kept digging through the harness and pulling his hair out. Turned out one contact on a 38999 had pushed back just enough to lose grip once the plug was mated and under a little side load. He never did buy a real retention gauge, just started doing the push and wiggle on every pin with a spare male contact before he mated anything. Cheap habit that would have saved him two days, honestly.