23
Did a deepwater weld inspection off the coast of Galveston and saw something sketchy with the anode placement
I was out on a job near the Galveston jetties last Tuesday, inspecting a riser at about 90 feet. Noticed the anodes were bolted too close to the weld zones, like within 6 inches. Anyone else run into this on offshore pipelines and have to decide whether to flag it or just let it slide?
3 comments
Log in to join the discussion
Log In3 Comments
susan8115d agoMost Upvoted
Flagging stuff" is better than watching it fail later.
5
Flagging stuff like that is the kind of thing that separates a good job from a "we'll fix it later" mess. It's like when you see someone park like a jerk in a lot and you just know they cut corners everywhere in their life too.
3